HARZO two-component varnish mixing

Mixing two-component Varnish, step by step.

HARZO products are always water-based materials! Mix all materials thoroughly before use. The tools can be washed with water!

Products sensing for it:

HARZO VARNISH two-component water varnish (component A+B)

How to mix:

The mixing of varnish begins with the mixing of component A, followed by the mixing and mixing of components A and B in a clean bucket. Using a drill with a clean mixing mud, mix the two components for 3-4 minutes to get the chemistry processes started. In case you need to mix a little material and you can’t use the mixing machine mixing, mix it manually with a brush and increase the mixing time by 2-3 minutes. After mixing, you have about 2 hours to a soak up the varnish, after which the varnish begins to dry into the bucket. Mix as much material as you can process in 1-2 hours. After mixing components A and B, processing can be done with a brush, roller, spray gun. It is recommended to apply it in two layers, it can be in three layers at higher loads.

If it is necessary to divide the varnish, measure it in several directions, use a digital household scale for weighing and take care to ensure that the weight ratios are accurately observed.

Always work with a clean roller, brush and scraper grid!! For varnishing, it is worth applying a new roller, brush, scraper grille per layer if you cannot wash it thoroughly!

Recommendation: In case of dry varnish fragments from the side of the bucket after mixing component A. Using a stocking, filter component A into a clean bucket and pour component B into it, then mix as described above.

Drying time: about 2-3 hours, which depends on the air temperature and ventilation possibilities.

Coverage: approx. 8-11 m2/litre/layer/

Packages of HARZO Varnish (ferry A+B):